2.1.3_I LITHIUM METAL CELLS PACKED WITH EQUIPMENT (including lithium alloy cells) Fully regulated cells UN 3091 Applies to: Lithium metal cells packed with equipment, with a lithium metal content in excess of 1 g/cell UN No., Proper Shipping Name UN 3091, LITHIUM METAL BATTERIES PACKED WITH EQUIPMENT Class 9 Packing Group Not assigned Hazard Label Labels must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; except for air transport mode, labels dimensions may be reduced not less then 30mm by 30mm on small packages. • They must have a line 5 mm inside the edge and running parallel with it. Prerequisite • Cells must meet the General Requirements of § 1.3 in particular the test requirements Specific Requirements • Each cell incorporates a safety venting device or is designed to preclude a violent rupture under normal conditions of carriage; • Each cell is equipped with an effective means of preventing external short circuits • “Equipment” means apparatus requiring the lithium batteries with which it is packed for its operation. Transport mode Road Marine Air Passenger Aircraft Cargo Packing instructions P903 P903 PI 969 section I Cells must be protected against short circuit, including protection against contact with conductive materials within the same packaging that could lead to a short circuit. Two possible solution, lithium metal cells must: • be completely enclosed in inner packagings, then placed in a UN packaging of the type shown below that meets the Packing Group II performance standards, then placed with equipment in a strong, rigid outer packaging; or • be placed in inner packagings that completely enclose the cells, then placed with equipment in a packaging that meets the Packing Group II performance standards of a type shown below. The equipment must be secured against movement within the outer packaging. Cells must be packed: - in a rigid metal intermediate or - in a metal outer packaging Cells must be surrounded by non-combustible and non-conductive cushioning material before being placed in the metal intermediate or metal outer packaging Packages not conforming to “Passenger Aircraft” requirements must be transported as “Cargo Aircraft Only” Packagings Drums (1A2, 1B2, 1N2, 1H2, 1D, 1G); Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H1, 4H2) Jerricans (3A2, 3B2, 3H2). Drums (1A2, 1B2, 1N2, 1H2, 1D, 1G); Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H2) Jerricans (3A2, 3B2, 3H2). Weight limit No limit No limit 5 kg Net 35 kg Net Exemptions (domestic voyage) Chapters: 1.15 up to 150 kg/vehicle 1.16 up to 150 kg/vehiclle chapter 11.2 - - Passenger Carrying Road Vehicle 5 kg - - - Marking and Labelling of Packages UN 3091 UN 3091 LITHIUM METAL BATTERIES PACKED WITH EQUIPMENT UN 3091 LITHIUM METAL BATTERIES PACKED WITH EQUIPMENT Full Name ad Address of the shipper and the consignee Net weight (kg) Minimum dimensions: 120 × 110 mm Overpack OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above Documents Transport document Transport document Shipper‘s Declaration 56 Copyright © www.batteriestransport.org
RkJQdWJsaXNoZXIy MjQwNg==